Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)08-01-60]
Rev.0.1
INST(RM)08-01-60
3. De-Installation Procedure of Service Processor
(1) <Setting the SVP RAS switch#1 on SSVP1 to ON>
(a) Loosen the screw and rotate the switch cover of the SVP RAS switch upward. Then, tighten
the screw.
(b) Set the SVP RAS switch#1 on SSVP1 to ON (lower position). To set the switch, use an object
with a sharp edge such as a pen and precision screwdriver.
NOTE: Use an object with a sharp edge such as a pair of tweezers to manipulate the SVP
RAS switch.
Figure 8-3 SVP RAS Switch Setting
ON
1 2 3 4
Front view of SSVP
Cover
Screw
SVP RAS Switch #1
HSNBX-1
HSNBX-0
SSVP1
SSVP0
Front view of HSNBX
To Next Page
Loading...
