Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)11-04-30]
Rev.2
INST(RM)11-04-30
5. Removing components
NOTICE: When removing the BKMF, hold it with both hands and remove it straight not to apply
a shock to the connector.
Connecter
Connecter
BKMF (Rear view)
(1) Remove all BKMFs (four) installed in the Controller Board.
(a) Loosen the screws (blue) fixing the BKMF.
(b) Open the lever and pull out the BKMF to remove.
Figure 11-2 Removing BKMFs (DKC-0)
Lever
DKC-0
Screw (blue)
BKMF
BKMF(FANM)
To Next Page
Loading...
