Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)11-05-10]
11.5 Confirming the Normality of the Storage System after Removing Controller Boards
1. Checking Normality
Perform the procedure described in "Checking Normality" (TRBL02-06-10).
2. Executing LAN Check
Perform a diagnosis of LAN Check (DIAG03-10).
When there is an error, perform “Recovery Procedure for Error Parts Detected by LAN Check”
(TRBL02-04-440).
3. Click [Logout] to close the window.
4. Click [Execute]-[Exit] in the SVP window to exit the window.
NOTE: At this point, the removed CTLs are displayed as selectable CTLs for “Connect to”.
5. Removing the Maintenance PC
Remove the Maintenance PC from the storage system referring to “Attachment/Removal Procedure of
Maintenance PC” (INST(IN)13-02-10).
Rev.2
INST(RM)11-05-10
To Previous Page
Loading...
