Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)03-01-71]
NOTE: Turn on the LOCATE LED by using Maintenance Utility during maintenance work.
If you cannot turn on the LOCATE LED, check the number (*2) shown on the label
attached to the lower left part of the front side of FBX so that you do not confuse the
maintenance target.
For correspondence of DKU# (DKU-xy(n)) to DB# (DB-zzz) and HDD location#, see
“Correspondence of DKU# to DB# and HDD Location#” (LOC02-84).
NOTICE: To prevent part failures caused by static electrical charge built up on your own body,
be sure to wear a wrist strap connected to the
Storage System
before starting and
do not take it o until you finish. See “Note when Installing and Removing Parts”
(INST(GE)01-01-10).
Rev.7
INST(RM)03-01-71
To Next Page
Loading...
