Hitachi DV-PF7E - How to Verify the Firmware Version

3-20
10.Press [CLEAR/C.RESET] button on the remote
control unit.
Fig. h appears on the screen.
When “OK” appears on the screen, the factory
default will be set. Then the firmware renewal
mode is complete.
11.To exit this mode, press [y/I ] button.
3-2-2 How to Verify the Firmware Ver-
sion
1. After making sure that no disc is in unit, turn the
power on.
2. Press [1], [2], [3], [4], and [DISPLAY] buttons on
the remote control unit in that order. The Firmware
version appears on the VFD and TV screen.
3. Turn the power off to reset the unit.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EXIT: POWEREEPROM CLEAR : CLEAR
"
*******
" differ depending on the models.
Fig. h