Number Item
1 Pin
2 Clip
3 Washer and bind screw
4. Position the controller so the front faces the front of the rack, and then slide the
controller gently onto the rails. Stop sliding when the mounting flanges on the front of
the controller touch the vertical face of the rack.
Note: Check the rear of the controller chassis to be sure the chassis is fit
securely into the stoppers.
Number Item
1 Stopper
5. On the front of the controller chassis, attach the two bind screws and washers to each
side of the rack.
Step 3: Install the controller into the rack
Installing your storage system
Hitachi Virtual Storage Platform E1090 Installation Guide 8
To Next Page
Loading...
