6. Type the new case-sensitive password for the maintenance user in New Password and
Re-enter Password. For security, each typed password character is masked with a dot.
Important: This password is required for storage system maintenance and
for running the Initial Setup wizard. Record the new password for the
maintenance user and keep it in a safe location.
7. Click Finish, and then click OK, Apply, and Close.
Next steps
Run the Initial Setup wizard.
Running the Initial Setup wizard
The Initial Setup wizard allows you to configure system information, date and time settings,
and network settings.
The Initial Setup wizard settings are presented on three windows. Buttons at the bottom of
each window allow you to apply or skip the settings on that window. If you skip settings, you
can complete them later by running the Initial Setup wizard again. To display details about
the settings in the windows, click the question mark icon in the bottom right.
Procedure
1. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
Tip: Initial Setup Wizard is near the bottom of the navigation tree. If you do
not see this selection, scroll down the tree.
Running the Initial Setup wizard
Installing your storage system
Hitachi Virtual Storage Platform E1090 Installation Guide 18
To Next Page
Loading...
