raidcom add path
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2EDA 00EE The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2EDA FEEC An internal error occurred.
Call Hitachi Data Systems customer support.
Get Command
Status
Async 2EDA FFFF An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS platform (System LU).
CMDRJE Executing B980 B902 The command was rejected because the specified
port is for NAS platform (User LU).
Table 9-103 SSB codes returned by raidcom -logout
raidcom -logout
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E01 2200 Failed to release the resource lock.
Table 9-104 SSB codes returned by raidcom monitor pool
raidcom monitor pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 6000 The value of pool ID is out of range.
CMDRJE Executing 2E10 6004 Monitor cannot be started because the
performance monitor is in the collecting status.
CMDRJE Executing 2E10 6005 Monitor cannot be stopped because the
performance monitor is stopped.
CMDRJE Executing 2E10 6006 Monitor cannot start because the performance
monitor is in use. Retry the operation after
completing or stopping the reallocation of Tier.
CMDRJE Executing 2E10 6007 There is not enough time after collecting
performance monitor.
CMDRJE Executing 2E11 6003 The pool is not in the state of specifying the
performance monitor to start or stop.
CMDRJE Executing 2E20 6000 The pool ID is not installed.
CMDRJE Executing 2E21 8101 A shared memory for Dynamic Provisioning is not
installed.
9-154
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
