Table 9-138 SSB codes returned by raidcom send ping
raidcom send ping
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 8400 The value of the specified port is invalid.
CMDRJE Executing 2E02 8403 The specified virtual port number is out of range.
CMDRJE Executing 2E10 8400 The specified port is blocked.
CMDRJE Executing 2E10 8404 The iSCSI virtual port mode for the specified port
is disabled.
CMDRJE Executing 2E10 8405 The IP version of the specified IP address is not
enabled.
CMDRJE Executing 2E11 8004 The operation cannot be performed because the
internal processing is in progress.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
CMDRJE Executing 2E20 8400 The specified port is not installed.
CMDRJE Executing 2E20 8401 The specified virtual port is not defined.
CMDRJE Executing 2E3F 8000 The specified operation is not supported in the
current microcode version.
Table 9-139 SSB codes returned by raidcom add rcu_iscsi_port
raidcom add rcu_iscsi_port
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 3005 The product ID is invalid.
CMDRJE Executing 2E02 9C01 The specified IP address is invalid.
CMDRJE Executing 2E20 3000 The serial number or product ID of the target
storage system is incorrect.
CMDRJE Executing 2E21 810A The shared memory is not installed.
CMDRJE Executing 2E22 3202 The specified RCU port is already registered.
CMDRJE Executing 2E22 9B02 The total number of registered iSCSI targets and
RCU ports in the storage system reached the
maximum.
CMDRJE Executing 2E22 9B03 The total number of registered iSCSI targets and
RCU ports per port reached the maximum.
CMDRJE Executing 2E30 840A The port attribute is not Initiator (MCU).
CMDRJE Executing 2E31 8301 The specified port is not a port of the package for
iSCSI.
9-178
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
