Precautions (Basic precautions)
(*1) UX2/UX/RX2 : [Technical Manual] 3.1 Print head air purge
When the end of the print head becomes dirty because the distance between the print head and the target is too close
and ink splashing occurs.
When you use the ink for which the need for air purge is described in the handling guidance of each ink.
[Note] Depending on the ink, "Air purge" is required regardless of the usage environment.
On the contrary, there is case installing is not available. Please see "Precautions
for each ink".
Do not drain the ink or makeup waste solution into public sewer systems or elsewhere.Waste disposal must
comply with all appropriate regulations. Have the used wiping papers and the empty container disposed by an
industrial waste processor. Consult the appropriate regulatory agency for further information.
Depend on usage environment, air purge is necessary. Below is the conditions under which air purge is required.(*1).
Consideration of "Air purge" Install
When the printer is used in a high-humidity environment, such as a beverage can or beer can line (Perform air purge
when using it in the 85 % RH or higher humidity environment.)
When a water drainage blow sequence is performed before printing.
When you use the printer in an environment with a lot of paper powder or dust.
Please read SDS(Safety Data Sheet) of purchased ink and makeup.
Store inks and makeups in the cold dark place (0 to 20℃ ).(Please store them in the same way regardless before and after
opening cartridge/bottle.)
There is an opening deadline for inks and makeups. Please fill them into the IJ printer before the "Expiration date" described
on the cartridge/bottle. ("Expiration date" means "Opening deadline".)
Once the cartridge/bottle is opened, even if it is stored in a cold dark place, the ink begins to deteriorate in the same manner
as the ink in the printer. If "Ink Replacement Cycle" base on guideline have passed, dispose the ink.
[Note] Regarding to (3) and (4), please see detail on following "[v] Guideline for the "Ink Replacement Cycle"
and applicable makeup" .
To Next Page
Loading...
