Hitachi IJ - Page 7

[ v ]
[ vi ]
[ vii ]
※
1113K
1113K
1113K
1113K
Base solvent
1113K
1113K
[ v ]
1113K
1113K
1113K
1113K
1113K
1113K
[ vi ]
1113K
Guidelines for stoppable period (Days printer can be stopped)
1113K
35-40℃
1113K
14 days
1113K
1113K
1113K
[ vii ]
1113K
1113K
1113K
Estimated
operating
hours
1113K
1113K
1113K
1113K
Days printer can be stopped
21 days
7 days
Required operating minimum hours to prevent ink viscosity decrease
Please operate IJ printer for at least following hours per start-up of IJ printer.
For single nozzle
For Twin nozzle ((UX-D860J/W))
Hours operating on IJ printer
Months since filling ink (or opening bottle)
600 - 1200 hours
6 months
Stoppable period and Long-term shutdown
Storage temperature
0-35℃
40-45℃
1113K
Applicable Makeup
S1018 / TH-18
MEK
Guideline for the "Ink replacement cycle"
Guideline of replacement timing to new ink is the earlier of the following.
For customer
Attachment for "Basic Precautions"
Detailed values for the following notes described in the main document depend on ink. Please
refer to the contents described in the table of this document and use IJ printer and ink. Applicable
makeup for each ink is described also.
Guideline for the "Ink replacement cycle"
Stoppable period and Long-term shutdown
Required operating minimum hours to prevent ink viscosity decrease
Depending on the ink, there may be special precautions. In this case, please see
"Precaution for each ink" also.
Value of "Basic precautions [v], [vi] and [vii]" for each ink