Preparations
Connecting the power supply
Before connecting the power, make
sure that the power switch is in the OFF
position (the side marked “O”).
1.
Connect the power cord connector
to the projector’s AC inlet.
2.
Plug the power cord's plug firmly
into a power outlet.
► Use extra caution when connecting the power cord as
incorrect or faulty connections may result in fire and/or electrical shock.
• Use only the power cord that came with the projector. If it becomes damaged,
contact your dealer for a new one.
• Only plug the power cord into an outlet rated for use with the power cord's
specified voltage range.
• Never modify the power cord. Never attempt to defeat the ground connection of
the three-pronged plug.
• The power outlet should be close to the projector and easily accessible.
• Do not touch the power cord with wet hands.
• Check that the power cord connector is clean (no dust) before using. Use a
soft, dry cloth to clean the power cord.
• Insert the power plug into the power outlet firmly. Avoid using loose, unsound
outlets and contact failures.
WARNING
Power switch
Power cord
connector
AC inlet
To Next Page
Loading...
Need help?
General