50
MAINTENANCE
● Please unplug the power plug when cleaning the refrigerator.
Warning
■ When dirt is found
● Wipe off it immediately. It is recommended to clean once a year.
Power plug
Once or twice a year
Back / sides / floor of the refrigerator
Once or twice a year
Surface of door
Once a month
Shelves and Pockets
Once every 3 months
Liquid receivers
Once a month
Door gaskets
Once a month
Case
Once per 3 months
Pull the power plug out from the outlet and
remove dust, etc. with a dry cloth.
To prevent fire or electric shock
Pg.32
Remove the leg covers, raise the adjustable
mounts from the floor, pull the refrigerator
toward you, and wipe off the dirt.
Wipe the surface of door using
a soft cloth with lukewarm
water, and then wipe off with a
dry cloth.
Remaining adhesives on surfaces, if any,
can be removed by using a plastic eraser
and wiping it off with a dry cloth.
Use a soft cloth
with lukewarm
water to clean.
How to remove
Pg.54
Use a soft cloth with
lukewarm water to clean.
Wipe off liquid residues and dirt.
Use a soft cloth wet with
lukewarm water to clean.
Wipe it thoroughly because it can
easily become dirty.
Use a soft cloth with lukewarm water to wipe off.
How to remove
Pg.55
Alkaline or weak alkaline kitchen detergents (other than neutral),
glass detergents, chlorine bleach
Scrubber, polishing
sponge, chemical rag
Polishing powder,
soap powder
Boiling
water
Benzine, thinner, alcohol
Liquid receivers
● Do not use the following items because it may cause damage and discoloration of the door, paintwork and plastic parts.
Confirm the
“
Liquidity
”
column of
“
Indication based on the Household Goods Quality Labeling Act
”
of detergent.
● Please wipe off spilled cooking oil, citrus fruits juice and food soup, as it may cause damage and discoloration of the door, paint work
and plastic parts.
● Do not wipe off lubricant applied to movable contact surfaces of cases and rails for the slide door.
● When a magnet or suction cup is attached on the side surface of the body or the surface of a door, it may leave some mark.
● When unplugging the power plug, the settings of the Control Panel may be released. So check the settings.
Request
・Due to the air convection around the back and side plastic parts, dust adheres
and gets dirty easily.
On an easily scratched floor, lay a protective board etc.
･ If there is a vibration noise, discolored back wall or dirt due to moisture, place
it 2cm or more away from the back wall.
How to remove the adjustable mounts.
Pg.36
Plastic parts (left and right)
※ Do not remove them.
To Next Page
Loading...
Need help?
General
