51
Press
“
Ice Maker
”
button for 5 seconds or more until the alarm
sounds.
When the 3 indicator lamps
“
Quick
”
,
“
On
”
and
“
Off
”
start to blink and alarm starts, stop
holding the button.
“
Ice Maker Cleaning
”
starts (for about 4 minutes).
・ The indicator lamp will flash and the buzzer will sound for about 4 minutes.
・
“
Ice Maker Cleaning
”
cannot be interrupted.
・ If you open any of the refrigerator doors during
“
Ice Maker Cleaning
”
, the cleaning may not work properly.
Do not open or close the door until cleaning is completed.
・ Door alarm will activated even if alarm is deactivated.
Pg.48
Ice Maker Cleaning
When using for the first time
When not used for more than 1 week
Please check the following before
starting the operation.
After checking, close all doors and then
perform the following operations.
Preparation
1
Place a clean towel, etc. on the bottom in the ice case so that
the cutout of the ice case can be blocked after the alarm and
blinking of the indicator lamp end.
Place a water-absorbing towel on the bottom in the ice case to prevent trapped water from
spilling out of the cutout of the ice case during the ice maker cleaning.
Wipe off water inside the ice case completely, and then place it
into the ice compartment.
Remove the towel with which you have wiped off water. You may continue to use the remaining
water in the water tank.
After
“
Ice Maker Cleaning
”
, it is resume back to
“
On
”
mode, etc.
2
3
Cutout
Towel
Water supply tank
・
Water is filled up to the
container-full line.
・
It is position correctly beyond
the tank set position line.
Ice case
・If there remains ice, remove it.
Wash the ice tray or water paths with water.
● Do not place your hand in the mechanical section of the
automatic ice maker.
(Rotation of the ice tray may cause injury.)
Warning
MAINTENANCE
Press for
5 seconds
Blinking
To Next Page
Loading...
Need help?
General
