Hitachi RCIM-1.5FSRE - Page 132

5 Optional functions
Optional functions through Remote control
SMGB0137 rev.0 - 05/2021
122
Element Optional function
Individual
setting
Settings Setting conditions Description
r1
Dual setpoint X
00
Function disabled
(factory setting)
This function allows the setting
of independent setpoints for
cooling and heating in the
automatic cooling/heating mode.
01
Function enabled
r2
Setting of temperature
di󰀨erential for switching
cooling and heating
X
0.5
0.5 ºC
This function can only be set
when function r1 is set to 01.
1.0
1.0 ºC
1.5
1.5 ºC
2.0
2.0 ºC
2.5
2.5 ºC
3.0
3.0 ºC
r3
Not used -
0.5
- Not used
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
5.0
5.5
r4
Not used -
00
- Use at 00 conditions
01
r5
Not used -
00
- Use at 00 conditions
01
r6
Not used -
00
- Use at 00 conditions
01
r7
Not used -
00
- Use at 00 conditions
01
r8
Not used -
00
- Use at 00 conditions
01
r9
Remote control prohibition
during setback operation
X
00
Start/Stop allowed (Factory setting)
Manual run/stop from the remote
controller can be disabled during
setback operation.
This function is xed to 00
(Disabled) when function qE is
set to 00 (Always).
01
Start/Stop not allowed
! DANGER
Blocking of Start/Stop shall never
be set due to safety concerns.
02
Only Stop allowed
rA
Not used -
00
- Use at 00 conditions
01
02
03
04
05
06
07