Hitachi RCIM-1.5FSRE - Removal Of The Fan Runner And The Fan Motor

7 Servicing
RCIM-(0.4-2.5)FSRE - 4-way cassette (compact)
SMGB0137 rev.0 - 05/2021
194
7.2.5 Removal of the fan runner and the fan motor
1 Remove the air inlet grille as indicated in “7.3.1 Removal of the air lter and the air inlet grille”.
2 Remove the bell-mouth. Remove the 4 xing screws attaching the bell-mouth to the drain pan and remove the bell-
mouth.
3 Removing the fan guide. Remove the 8 xing screws and remove the drain pan.
4 Removing the Fan runner and the Fan Motor
a. Remove the nut and the washer xing the fan runner.
b. Remove 3 nuts xing the fan motor.
c. Then remove the fan motor.
? NOTE
When reassembling these parts, tighten the nuts with a tightening torque of 8N-m.
Vibration
absorver
(3 pcs.)
Fixing nut
(3 pcs.)
Fan motor
Fan runner
Bell-mouth
Fixing nut
Fan guide
Fixing screw (x8)
Fixing screw (x4)