Hitachi RCIM-1.5FSRE - Removing Float Switch

7 Servicing
RCI-(1.0-6.0)FSR - 4-way cassette
SMGB0137 rev.0 - 05/2021
188
7.1.9 Removing oat switch
1 Remove the drain pan according to the item “7.1.6 Removing drain pan”.
2 Remove the insulation which attaches the wires for oat switch and drain-up mechanism together.
3 Cut the plastic band xing the wires at the xing plate for oat switch.
4 Removing Float Switch. The oat switch is attached next to the drain-up mechanism. Remove the oat switch by
loosening the xing screw for the xing base.
? NOTE
• When reassembling, wrap up the wires for oat switch and drain-up mechanism together by the insulation. Fix securely them to the
original position. When attaching the drain pan again, pay attention not to pull the wires strongly. Otherwise, the insulation attaching
at the cabinet may be peeled.
• Pay attention to handle the oat switch. If it is dropped to a oor, the malfunction may occur.
• When attaching the oat switch, tighten the screw by hand. (Do not use a motor-driven screwdriver).
Float switch
Nut
Fixing plate
for oat switch
Plastic band
Lead wires
Screw for
xing plate