1.2. General data for RHUE40~240AG2
MODEL RHUE40AG2 RHUE50AG2 RHUE60AG2 RHUE70AG2
Total Power input in cooling
Total Power input in heating
Continuous Capacity Control
Continuous Capacity Control
Continuous Capacity Control
Water side heat exchanger
Multi-Pass cross fi nned tube
Electronic expansion valve
Number of independent circuits
JAPAN ENERGY FREOL UX300 (Ester)
3” Victaulic (1xInlet/1xOutlet)
Chilled water outlet temperature
Heated water outlet temperature
Condenser air inlet temperature
-15~46 for cooling operation
Evaporator air inlet temperature
DB: -9.5~21/ WB:-10~15.5 for heating operation
Permissible water pressure max.
Permissible water pressure max.
Permissible water pressure max.
Safety and protection devices
Reverse Phase Protection, Fuse and Thermal Relay for Compressor,
Reverse Phase Protection, Fuse and Thermal Relay for Compressor,
Reverse Phase Protection, Fuse and Thermal Relay for Compressor,
Reverse Phase Protection, Fuse and Thermal Relay for Compressor,
Reverse Phase Protection, Fuse and Thermal Relay for Compressor,
Internal Thermostat for Compressor, Compressor Oil Heater,
Fuse and Internal Thermostat for Fan Motor, Control Circuit Fuse,
High Pressure Switch, Low Pressure Control,
High Pressure Relief Valve, Discharge Gas Temperature Control,
Suction Gas Temperature Control, Freeze Protection Control
and Compressor Operation Hour Meter
and Compressor Operation Hour Meter
and Compressor Operation Hour Meter
(1) The nominal cooling capacities are based on the European Standard EN12055.
Chilled Water Inlet / Outlet Temperature : 12/7 ºC
Condenser Inlet Air Temperature : 35 ºC
(2) The nominal heating capacities are based on the European Standard EN12055.
Heated Water Inlet / Outlet Temperature : 40/45 ºC
Evaporator Inlet Air Temperature : 6 ºC (WB)