6.1. Maintenance criteria
Check Item
Check
Frequency
Criteria (procedure) Remarks
Confi rm if there is no abnormal noise.
Confi rm visually if there is no abnormal vibration
Confi rm visually if there is no abnormal vibration
Perform repair painting with Anticorrosion paint
Confi rm if there is no refrigerant leakage by
using detecting device in each component
and pipe connection parts. As for checking
for leakage in water cooler and condenser,
confi rm it with the air discharged to water inlet
and outlet, and in this, case water should be
Perform visual check if there is no contact or
Confi rm if there is no abnormal noise at starting,
Confi rm if there is no oil leakage or bleed from
Perform visual check by sight glass.
Apply current during compressor stop.
Touch and confi rm if they have rubber elasticity.
Pay special attention to noise, vibration and oil
Confi rm if safety device and protection device
Overhaul the compressor and check it according
to the specialist’ advice.
Clean it spraying warm water (less than 40ºC).
Confi rm if they are within the criteria
Confi rm if it is within the criteria.
Confi rm if high pressure is within the criteria.
Perform the predetermined cleaning.
If condenser is not used for intermediate or long
period, drain water. At this time, open also plug
for draining water and for removing air.
for draining water and for removing air.