Table of contents
Section 1 Introduction..................................................................................................13
1.1 This manual.........................................................................................................................13
1.2 Intended audience...............................................................................................................13
1.3 Product documentation....................................................................................................... 14
1.3.1 Product documentation set................................................................................................14
1.3.2 Document revision history.................................................................................................15
1.3.3 Related documents........................................................................................................... 16
1.4 Document symbols and conventions...................................................................................16
1.4.1 Symbols.............................................................................................................................16
1.4.2 Document conventions......................................................................................................17
1.5 IEC 61850 edition 1 / edition 2 mapping............................................................................. 17
Section 2 Safety information....................................................................................... 23
2.1 Symbols on the product.......................................................................................................23
2.2 Warnings............................................................................................................................. 23
2.3 Caution signs.......................................................................................................................24
2.4 Note signs........................................................................................................................... 25
Section 3 Available functions......................................................................................27
3.1 Main protection functions.................................................................................................... 27
3.2 Back-up protection functions...............................................................................................29
3.3 Control and monitoring functions.........................................................................................30
3.4 Communication................................................................................................................... 37
3.5 Basic IED functions............................................................................................................. 41
Section 4 Starting up....................................................................................................45
4.1 Factory and site acceptance testing....................................................................................45
4.2 Commissioning checklist.....................................................................................................45
4.3 Checking the power supply................................................................................................. 45
4.4 Energizing the IED.............................................................................................................. 46
4.4.1 Checking the IED operation.............................................................................................. 46
4.4.2 IED start-up sequence ......................................................................................................46
4.5 Setting up communication between PCM600 and the IED................................................. 47
4.5.1 When IED has blank front panel........................................................................................47
4.5.2 When IED has front port with RJ-45..................................................................................47
4.6 Writing an application configuration to the IED................................................................... 51
4.7 Checking CT circuits........................................................................................................... 51
4.8 Checking VT circuits............................................................................................................52
4.9 Using the RTXP test switch ................................................................................................52
4.10 Checking the binary input/output circuits.............................................................................53
4.10.1 Binary input circuits........................................................................................................... 53
4.10.2 Binary output circuits.........................................................................................................53
4.11 Checking optical connections..............................................................................................53
1MRK 505 378-UEN Rev. K Table of contents
Line differential protection RED670 1
Commissioning manual
© 2017 - 2022 Hitachi Energy. All rights reserved
To Next Page