8 Electrical check of main parts
Automatic louver mechanism
SMGB0099 rev.0 - 12/2016
242
8.3.2 RCIM indoor units
Stop the automatic louver:
1 Press AUTO LOUVER on the remote control while the automatic louver is operating.
2 The crank touches the end of the motor securing plate and the louver returns to position 0.
3 The motor power supply switches off when the louver is at the set position.
4 The louver stops at the set position.
Removing the auto louver motors and the louver:
1 Remove the air panel:
a. Remove the auto swing motor connector (CN17)
from PCB.
b. Remove the corner pocket covers.
2 Remove the xing screw for C-cover and remove the
C-cover.
3 Remove the xing screw for AS Motor from the air
panel. Then remove the louver, louver bearing and AS
motor.
4 Remove the AS motor, stopper and bearing from the
louver.
5 Disconnect the connector for the AS motor. Press the
catch to disconnect the connector to avoid breakage.
Screw
Air panel
C-cover
Louver
Bearing
Connector
AS
Motor
Air panel
Bearing
Bearing
Louver
Stopper
AS Motor
Stopper
Pay attention to the
direction of the stopper
Air inlet side
Rib
To Next Page
Loading...
