Hitachi RPC-1.5FSN3 - Removal of the Float Switch

9 Servicing
RPI-(8.0-20.0)FSN3(P)E(-f) - Ducted indoor unit
SMGB0099 rev.0 - 12/2016
301
9
9.7.7 Removal of the oat switch

For RPI-(8.0/10.0)FSN3E(-f)
1 Remove all screws -A- from the lower cover of the unit and
separate it.
2 Remove the drain pan as indicated in chapter “9.7.5 Removal of
the drain pan”.
? NOTE
To disconnect and remove the oat switch, previously see the chapter
corresponding to the wiring diagrams in this Manual.
3 Loosen the resin nut securing the oat switch -A- and remove it.
If the switch support is to be removed, remove screws -B-.
? NOTE
The torque value of the resin nut is 0.3 - 0.4 Nm. If the torque value is
higher, the nut will be damaged.

For RPI-(16.0/20.0)FSN3PE(-f)
1 Remove the cycle service cover by unscrewing its xing screws
2 Loosen the resin nut securing the oat switch and remove it. If
the switch support is to be removed, remove screws.
? NOTE
The torque value of the resin nut is 0.3 - 0.4 Nm. If the torque value is
higher, the nut will be damaged.
Cycle
service
cover
Flow switch