2-67
SERVICING
(2.5 2-Way Cassette Type)
2.5.3 Removing Optional Air Panel
(1) Remove the electrical box cover by opening the air intake grille.
Disconnect the connector (CN17) for the auto-louver on the indoor PCB.
(2) Remove the air intake grille from the optional air panel.
Remove four (4) screws fixing the optional air panel.
(3) Remove the optional air panel after unhooking the hinge onto the hooks at the two positions near the
drain pan.
Phillips ScrewdriverTool
TURN OFF all power source switches.
Hinge
Hook
Connector for Louver Motor
PCB
CN4
CN7
PCN4
Optional Air Panel
Screws
Screw x 2
(M6x30, Only for P-G46)
PCB
2
(Before Alteration)
Connector for Louver Motor
PCB
2
(AC Chopper Model)
(After Alteration)
PCB
TB
To Next Page
Loading...
