Hitachi RPI-0.8FSG1 - Removing Printed Circuit Board (PCB)

2-98
SERVICING
(2.7 Floor Type)
Phillips ScrewdriverTool
TURN OFF all power source switches.
Phillips ScrewdriverTool
(5) Remove the electrical box cover after removing two (2) fixing screws.
2.7.6 Removing Printed Circuit Board (PCB)
(1) Remove the air intake grille according to the item 2.7.1 “Removing Air Intake Grille”.
(2) Remove the air filter according to the item 2.7.2 “Removing Air Filter”.
(3) Remove the front cover according to the item 2.7.4 “Removing Front Cover”.
(4) The side cover can be removed by removing the three (3) fixing screws and pulling it downwards.
Side Panel
Screws
Electrical Box Cover
Screws