2-80
SERVICING
(2.6 Wall Type)
Phillips ScrewdriverTool
TURN OFF all power source switches.
(4) Hold both sides of the front panel, pull the front panel toward the front side slowly and lift up the front
panel with paying attention not to touch the louver at the air outlet.
(5) Lift up the front panel slightly, the three (3) catches at the upper part of the front panel are detached
from the holes of the unit body and the front panel can be removed toward the front side.
NOTE:
Do NOT hit the front panel when removing the front panel. It may break the unit body.
(6) For attaching the front panel, attach the front panel at the air outlet side firstly, and attach three (3)
catches at the upper part of the front panel.
(7) Open the front panel as the procedure (1), and fix the screw (1 piece) at the center of the front panel.
2.6.2 Removing Front Panel
(1) Press the “PUSH” marks at both ends of the front panel and open the suction grille by pulling toward
the front side.
(2) Remove one (1) screws at the center of the front panel. After removing the screw, close the front
panel once.
(3) Remove three (3) bushes at the louver part of
the air outlet and remove three screws.
Bush Screw
Screws
Front Panel
Front Panel
Extrusion
Square Hole
Front Panel
Unit Body
To Next Page
Loading...
