2-71
SERVICING
(2.5 2-Way Cassette Type)
2.5.6 Removing Float Switch
(1) Remove the air intake grille according to the item 2.5.1 “Removing Long Life Filter and Air Intake
Grille”.
(2) Remove the bell-mouth according to the item 2.5.4 “Removing Fan Runner and Fan Motor”.
(3) Remove the cover after removing two (2) fixing screws for the cover of the service access hole near
the pipes inside the unit.
(4) Removing Float Switch
Disconnect the connectors and remove the float switch after removing two (2) screw fixing the fixing
plate for float switch onto the fixing plate for the drain-up mechanism.
Phillips ScrewdriverTool
TURN OFF all power source switches.
Service Access
Cover
Fixing Screws
Connector
Screws
Fixing Plate for
Drain-Up Mechanism
Float Switch
Fixing Plate for
Float Switch
To Next Page
Loading...
