4-42
OPTIONAL FUNCTION
(4.4 Remote Control Switch)
NOTES:
1. (*1): This function is applicable for RCI and RCD models. In case of RPI-0.8 to 5.0FSG1 series,
“Hi Speed 1” is “High External Pressure Setting” and “Hi Speed 2” is “Low External Pressure Setting”.
2. As for the optional functions with “ X ” at the individual setting, only when the “All Rooms” is selected to set
the optional function, the setting condition can be changed.
3. The items “C1” and “C3” are not available. Do not change the setting condition “00”.
4. For the models RPF(I)-FSG(E), RPI-8, 10HP, RPC-FSG1 (Before Alternation) and RPK-FSGM (Before
Alternation), only the function setting of No.1 to No.9, No.17 and No.30 are available.
(No.17 is settable “01” only.)
00 Not Available
01 Available
00 Not Available
01 Available
00 Control by Indoor Suction Thermistor
01 Control by Thermistor of Remote Control Switch
02 Control by Average Value of Indoor Suction
Thermistor and Thermistor of Remote Control
Switch
18 C9
Not Prepared
−
19 CA
Not Prepared
−
00 Forced Stoppage Input A Contact
01 Forced Stoppage Input B Contact
21 CC
Not Prepared
−
00 Not Available
01 Available
23 d2
Not Prepared
−
00 Not Available
01 Available
00 Automatic Ventilation
01 Ventilation by Total Heat Exchanger
02 Bypass Ventilation (No Total Heat Exchanging)
00 Not Available
01 Available
27 E3
Not Prepared
−
00 Standard
01 30 minutes
02 60 minutes
29 E5
Not Prepared
−
00 No Function
01 OFF Timer by 1 hour
02 OFF Timer by 2 hours
M
23 OFF Timer by 23 hours
24 OFF Timer by 24 hours
00 Main
01 Sub
28 E4 Precooling/Preheating Period
24 d3 Power Supply ON/OFF 2
25
26 E2 Increasing Supply Air Volume
20 Cb
Selection of
Forced Stoppage Logic
E1 Ventilation Mode
22 d1 Power Supply ON/OFF 1
17 C8
Thermistor of
Remote Control Switch
30 F1
Automatic Setting for
OFF Timer
15 C6
Hi Speed at Heating
Thermo-OFF
16 C7
Canceling of
Enforced 3 Minutes
Minimum Operation Time
of Compressor
31 F2
Remote Control
Main-Sub Setting
To Next Page
Loading...
