6-2
6.2 Parameter Settings
Before starting the communication, configure the
following inverter settings as necessary.
6.2.1 Initialization
Configure the parameter [Ub-01] (Initialize mode
selection) to 04 (Error history clear & Data
initialize & EzSQ clear), and the parameter [Ub-05]
(Initialize enable) to 01 (Initialize start), then the
inverter settings will be initialized.
6.2.2 This device and the client
(higher-level device) correlating
parameters
The following table shows the inverter setting
parameters and their contents related to this
product and the client (higher-level device). This
device reads and implements the following setting
parameters from the inverter when it is powered
on.
■Parameter
When configuring the inverter setting parameters,
not only read this guide but also the inverter's
guide and the client (higher-level device)
instruction manual.
The following settings are implemented in this
device when the inverter is powered on. Make sure
to restart the inverter after configuring the
parameters.
Communication speed (PORT1)
00(Auto Negotiation)/
01(100M: Full-duplex)/
02(100M: Half-duplex)/
03(10M: Full-duplex )/
04(10M: Half-duplex )
Communication speed (PORT2)
00(Auto Negotiation)/
01(100M: Full-duplex)/
02(100M: Half-duplex)/
03(10M: Full-duplex )/
04(10M: Half-duplex )
Ethernet communication timeout
Modbus TCP port No. (IPv4)
Modbus TCP port No. (IPv6)
IPv4 IP address (1), Gr. 1
IPv4 IP address (2), Gr. 1
IPv4 IP address (3), Gr. 1
IPv4 IP address (4), Gr. 1
IPv4 sub-net mask (1), Gr. 1
IPv4 sub-net mask (2), Gr. 1
IPv4 sub-net mask (3), Gr. 1
IPv4 sub-net mask (4), Gr. 1
IPv4 default gateway (1), Gr. 1
IPv4 default gateway (2), Gr. 1
IPv4 default gateway (3), Gr. 1
IPv4 default gateway (4), Gr. 1