Hitachi SJ Series - Page 22

4-8
Chapter 4
Safety Function
4.4.7 Parameter setting
The parameters of safety function set to P1-FS are
configured on PC software ‘ProDriveNext’ whose version is
2.3.22.0 or later. In this case, please check that the version
of ‘Hitachi Inverter Tool’ is 2.1.28.1 or later. ‘Hitachi
Inverter Tool’ is included in ‘ProDriveNext’.
Parameter setting to P1 should be set with the
conventional parameter setting method (keypad,
ProDriveNext, via communication).
■From ProDriveNext launching
to connection to P1-FS
[1] The following screen will be displayed after launching
ProDriveNext and setting up the connection mode of
online or offline.
When the connection is online, go to [2]. When the
connection is offline, go to [3].
[2] Click the P1-FS settings, the following confirmation
screen will be displayed, click "Yes" to proceed to P1-FS
setting.
※Please be sure to insert and fix P1-FS into the P1 slot
(toward the far right).
USB
Micro B
connector
USB
A connector
[ProDriveNext] installed
Windows PC
SJ-P1