Hitachi SJ Series - Page 69

11-1
Chapter 11
Specification and Technical data
Press the grey
part with
flat screwdriver
Pull out the wire
Pull out the flat
Screw driver
11.1 Contents in this chapter
This chapter describes the specification related to P1-FS
terminals and its technical data.
Note 1: Supplier: Phoenix contact
Crimping pliers: CRIPMFOX 6
■ Wiring connections
Insert
Insert the ferrule terminal into the P1-FS terminal block.
It will be easy to insert without any tools if use the correct
ferrule terminals.
■ Methods to detach the connector
Put down the locking lever according to the arrow
direction to unlock and pull out the connector, as
showed below.
11.2 Recommended ferrule
I/O terminal block is a spring-cramp type. For safe wiring
and reliability, it is recommended to use the following
ferrules.
Note 2: These specifications are different from the
recommended ferrule terminals for the inverter.
Pull out the wire
Press the grey part on P1-FS terminal block with flat
screwdriver（width lower than 2.5m） to open the wire
port.
Press the flat screwdriver and pull out the wire or the
ferrule terminal
Pull out the flat screwdriver.
The real color of the grey part on the terminal block is
orange.
Wire size
mm
2
(AWG)
Model name of
ferrule
*1, 2
L1 [mm]
L2 [mm]
φd [mm]
φD [mm]
0.25 (24)
AI 0,25-10YE
10
14.5
0.8
2.0
0.34 (22)
AI 0,34-10TQ
10
14.5
0.8
2.0
0.5 (20)
AI 0,5-10WH
10
16.0
1.1
2.5
0.75 (18)
AI 0,75-10GY
10
16.0
1.3
3.4
11
Chapter 11 Specification and
Technical data
Put down
the lock lever
Pull out the connector
Wire inserted