Hitachi SJ700B SERIES - Page 248

Chapter 7 Specifications
7 - 3
(3) Specifications of the 400 V class models (continued)
Model name (type name)
SJ700B-□□□HFF
055 075 110 150 185 220 300 370
450 550
Operating
environment
Ambient
temperature,
storage
temperature(note5),
humidity
-10°C to 45°C (ambient), -20°C to 65°C (storage), 20% to 90% RH (no condensation allowed)
Vibration tolerance
(See Note 1.)
5.9m/s
2
(0.6G),10～55Hz 2.94m/s
2
(0.3G),10～55Hz
Installation
environment
Environment without corrosive gases and dust, at an altitude of 1,000 m or less
Coating color Gray
Optional boards
Feedback option
Vector control with sensor
Digital input option 4-digit BCD input, 16-bit binary input
DeviceNet option Option to support the open-network DeviceNet function
LonWorks option Option to support the open-network LonWorks function
Profibus-DP option Option to support the open-network Profibus-DP function
Other optional components
Braking resistor, AC reactor, DC reactor, noise filter, operator cables, Harmonic-wave suppressor unit,
LCR filter, analog operation panel, regenerative braking unit, controllers for various applications
Note 1: The vibration tolerance was tested in compliance with JIS C0040 (1999).
Note 2: The insulation distance complies with the UL and CE standards.
Note 3: The applicable motor refers to Hitachi standard 3-phase motor(4-pole).when using other motors,care must be taken to
prevent the rated motor current(50/60Hz)from exceeding the rated output current of the inverter.
Note4:Function “64(EMR)”cannot be assigned to input terminal 3 by an operation from the operator. The function is automatically
assigned to the terminal when slide switch SW1 is set to ON.
Note5:The storage temperature refers to the short-term temperature during transport.
Note6:The frequency command will equal the maximum frequency at 9.8V for input voltage 0 to 10VDC,or at 19.6mA for input current
4 to 20mA.If this characteristic is not satisfactory for your application, contact your Hitachi sales representative.