Checking SIM reference codes
All SIMs are recorded in the storage system. When a SIM is output, Warning or Failed is
displayed at the upper left of the Maintenance Utility window to notify users.
You can check SIMs on the Alert tab in the Maintenance Utility window. For details, see
the System Administrator Guide.
Searching for SIM reference codes
In the SIM code lists, SIM codes that begin with the same digits are listed as a single
code. For example, 602001 is shown as 602xxx (xxx indicates a pool number) in the SIM
code list. Therefore, when searching for a SIM code, use the rst few digits, 602 in this
case, as a key word.
Handling failures
There are two types of SIMs. One can be handled by users, and the other must be
handled by service personnel. For SIMs that can be handled by users, see the recovery
procedures of the SIMs described in the applicable user guide to solve the problem. For
the SIMs that must be handled by service personnel, contact the customer support. See
SIM code list for troubleshooting by users (on page 11) or SIM code list for
troubleshooting by service personnel (on page 13) for the SIM code lists.
Checking SIM reference codes
Chapter 1: Service Information Message (SIM) overview
SIM Reference Guide for VSP E Series, and VSP G130, G/F350, G/F370, G/F700, G/F900 8
To Next Page
Loading...
Need help?
General