Advanced Techniques
47
Creating a Title
1. Connect the camcorder to a power source.
2. Hold down the red button on the CAM/OFF/VIDEO switch and slide it to either CAM or
VIDEO.
3. Press the TITLE ON/OFF button on the remote control and a flashing cursor appears in the
viewfinder.
4. Use the STOP button to place the cursor where you wish to begin your title.
5. Use the F.F and REW buttons to select the first character of your title.
6. Once you've selected a character press the STOP button to set it.
7. Complete the title by repeating steps 5 and 6.
8. When you complete your title, press the TITLE ON/OFF button on the remote control to
store the title in memory and remove the title graphics from the viewfinder.
Note: As long as the correct current time can be displayed, the title is held in memory.
Correcting Errors
1. Press the TITLE ON/OFF button on the remote control.
2. Use the STOP button to select the character to be corrected.
3. Use the F.F and REW buttons to correct the character.
4. Press the TITLE ON/OFF button on the remote control to store the corrected title in
To Next Page
Loading...
Need help?
General
