Advanced Techniques
49
camcorder shown above.
Note: The wireless remote control may not function in strong light such as direct sunlight or
very bright artificial lighting.
Note: Clear a direct path from the wireless remote control to the infrared ray receiver. The
wireless remote control won't work if an obstacle blocks the infrared rays.
Note: The remote control code of this camcorder is Hitachi code VCR2. If you have a VCR
with the same code you Hitachi VCR may malfunction when you use the camcorder's
wireless remote control.
How to attach remote control to the shoulder strap (The remote control is
optional for VM-E110A)
It is recommended that you fit the remote control into the holder and attach the holder to
the shoulder strap so as not to lose the remote control and for convenience when
shooting outdoors.
1. Attach the holder to the shoulder strap.
2. Attach the remote control to the holder. Fit the remote control into the holder as
shown in the figure below and push until a click is heard.
To remove the remote control
Push both sides of the holder until the remote control is released from the tab. The rear
of the remote control will be released from the holder and will lift slightly.
Dubbing from the camcorder to a VCR
15
Connect the camcorder to a VCR to copy your or a friend's home 8mm recordings to VHS.
Camcorder to VCR connection Illustration
1. Connect your camcorder to the VCR, following "Playing Back Your Recording" on
To Next Page
Loading...
Need help?
General
