When the linear time counter with memory indication appears in the viewfinder, a tape
that is being rewound automatically stops when the counter reads approximately
"0:00:00 M". This is useful if there is a section of tape you want to review immediately
after recording or if you want to return to the same point several times in a row.
1. Press "DISPLAY" button until the linear time counter with memory is displayed.
2. Start playing or recording a tape.
3. At the point you want playback to start, press "RESET" button to reset the counter to
"0:00:00M".
4. Continue to play or record.
5. Press "STOP" button.
6. Press "REW" button. The tape will be rewound to the preselected point, at
approximately "0:00:00M" indication.
[NOTE:The tape will also stop approXimately at "O:O0:OOM" during fast forward mode.
To Next Page
Loading...
