Synchro edit allows your camera/recorder to control a compatible VCR (one that has a
camera pause jack) while tapes are being copied from the camera/recorder to the VCR.
This is convenient when you want to record only selected segments from a previously
recorded tape.
Synchro edit hookup Illustration
1. Connect your camera/recorder to a compatible VCR as shown above. An optional
synchro edit cord is required
INOTE:If your VCR hasa single (m0no)audio input connect either the left or right audio]
plug to audio input on the VCR
2. Turn the operate control to select "VCR".
3. Insert the recorded tape into the camera/recorder.
4. Insert the blank tape into the recording VCR.
5. Press "PLAY" button on the camera/recorder and the press "PAUSE" button where
you want to copy.
6. Press "RECORD" button on the VCR. The VCR automatically enters record/pause
mode.
I NOTE: If the VCR begins to record instead of pausingl you wi!Ineed to change the position [
of the switch on the synchro edit cord. St0P the VCR, change the switch, and then press
RECORD button on the VCR again, l
7. Pressing "S.EDIT/REVIEW" button on the remote control puts the camera/recorder in
the review mode for several seconds and then into the playback mode. The recording
VCR starts recording automatically.
8. Pressing "REW", "F.FWD", "STOP" on the camera/recorder orr "PAUSE" on the
remote control automatically put the VCR into the record/pause mode. This allows you
to search (forward or backward), fast-forward or rewind the tape in the camera/recorder
without disturbing the tape in the VCR.
• To search forward (or backward), press "F.FWD" or "REW" button. When you press
"PLAY" button, the camera/recorder will resume normal playback. To begin copying
again, press "PAUSE" button and then the "REVIEW" button on the remote control.
• To fast-forward (or rewind) the tape, press "STOP" then "F.FWD" (or "REW"). To begin
copying again, press "STOP", then "PLAY", then "PAUSE" to pause the
camera/recorder, and "REVIEW" (on the remote control) to begin copying.
To Next Page
Loading...
