3. Remove the water-resistant seal carefully.
4. Wipe off foreign matter (sand, dust, etc.) from the grooves in the case.
5. Thinly coat the entire water-resistant seal with grease (provided).
6. Fit the water-resistant seal into the grooves in the case with its sharp edge forward.
NOTE:Do not push the seal in with tweezers or a Sharp object. If the Water'resistant seal is
damaged, it will allow Wate[ to enter.
7. Re-connect the power connector and re-attach the bracket in their original positions.
Storage
• Store the VM-SPIA in a well ventilated place, not in a place at high temperature and
high humidity or in a dusty place.
• Thinly coat the water-resistant seal with grease (provided) to prevent it from
deteriorating and store the VM-SPIA without closing the buckle and with the case
slightly open.
To Next Page
Loading...
