Hitachi VSP G130 - Page 11

The Initial Startup wizar
d allows you to enter the account settings and the IPv4 or IPv6
network settings used by the storage system. If you need to change these settings in the
future, run the Initial Startup wizard again.
Before you begin
Have the following conguration settings ready to enter in the Initial Startup wizard:
■
The default storage system password: raid-maintenance
■
The IP addresses for the two controllers and the SVP
■
The subnet mask (IPv4) or subnet prex length (IPv6) for the storage system
■
The default gateway for the storage system
■
The IP addresses for up to three DNS servers
Procedure
1. In the Remote Desktop Connection window, click the Start button, and then click
Hitachi Device Manager - Storage Navigator.
2. Right-click Initial Startup, point to More, and then click Open le location.
3. In the window that appears, right-click Initial Startup, and then click Run as
administrator.
4. When pr
ompted about allowing this app to make changes to your device, click Yes.
5. Click Start Setup.
Running the Initial Startup wizard
Installing your storage system that includes an SVP
Hitachi Virtual Storage Platform G130 (with SVP) Installation Guide 11