Hitachi VSP G130 - Checking Licenses; Running the Initial Setup Wizard

Checking licenses
Storage systems that are factory-installed in a rack already have software licenses
installed.
As a best practice, conrm that the appropriate licenses are installed.
Before you begin
Log in to Device Manager - Storage Navigator using Remote Desktop Connection.
Procedure
1. On the Maintenance Utility menu, click Licenses.
2. If a message reports a problem with the website's security certicate, click Continue
to this website (not recommended).
3. In the Licenses window, conrm that the appropriate licenses are installed. If they
are not, see the System Administrator Guide for instructions on installing licenses.
Next steps
Run the Initial Setup wizard.
Running the Initial Setup wizard
The Initial Setup wizard allows you to congure system information, date and time
settings, and network settings.
The Initial Setup wizard settings are presented on three windows. Buttons at the
bottom of each window allow you to apply or skip the settings on that window. If you
skip settings, you can complete them later by running the Initial Setup wizard again. To
display details about the settings in the windows, click the question mark icon in the
bottom right.
Before you begin
■
Using the production network IP address you specied in the Initial Startup wizard,
log in to the SVP via Remote Desktop Connection from your production network.
■
Log in to Device Manager - Storage Navigator.
Procedure
1. On the Maintenance Utility menu, click Licenses.
2. If a message reports a problem with the website's security certicate, click Continue
to this website (not recommended).
3. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
Tip: Initial Setup Wizard
is near the bottom of the navigation tree. If
you do not see this selection, scroll down the tree.
Checking licenses
Installing your storage system that includes an SVP
Hitachi Virtual Storage Platform G130 (with SVP) Installation Guide 16