Hitachi VSP G130 - Page 15

10. In the Complete Initial Startup window, click Conrm.
11. W
ait for the SVP to reboot (approximately 5 minutes).
12. Connect the LAN 1 port on the SVP to your production network.
Note: If your network has BPDU enabled to pr
event loops, connect the
user LAN port on controller 1 to an Ethernet switch on the production
network instead of attaching it to the SVP. Then refer to the
SVP
installation and maintenance instructions for the
Hitachi Vantara-
supplied SVP to congure the SVP for a non-bridged operation.
13. Using the new SVP IP address you specied in the Initial Startup wizard, log in to
the SVP via Remote Desktop Connection from your production network.
14. On the desktop, double-click the Open StorageDeviceList icon.
15. Mouse over the Storage Device List window to highlight it, and then double-click
the icon of the registered storage system.
16. Log in to Device Manager - Storage Navigator using the new maintenance password
you specied in the Initial Startup wizard, and then click Login.
Next steps
Verify that licenses are installed.
Running the Initial Startup wizard
Installing your storage system that includes an SVP
Hitachi Virtual Storage Platform G130 (with SVP) Installation Guide 15