Hitachi VSP G130 - Page 14

SVP Address IP address used to access the SVP via
your pr
oduction network. Default:
192.168.0.15
Subnet Mask IPv4 only. IP address mask that
identies the range of IP addresses in
the subnet to which the storage system
will be connected.
Subnet Prex Length IPv6 only. Subnet prex length of the
network to which the storage system
will be connected.
Default Gateway IP address of the default gateway to
which the storage system will be
connected. The gateway is the IP
address of the router used to
communicate outside the local subnet.
DNS Server 1
DNS Server 2
DNS Server 3
IP addresses for up to three Domain
Name Systems (DNS) servers.
8. Click Apply.
9. W
ait for the Initial Startup Complete message, and then click Close.
Note: If an err
or message appears, ping the IP addresses of the two
controllers and SVP. If you receive a response, repeat the Initial Startup.
If you do not receive a response, contact customer support.
Running the Initial Startup wizard
Installing your storage system that includes an SVP
Hitachi Virtual Storage Platform G130 (with SVP) Installation Guide 14