Hitachi VSP G400 - Page 339

Mode Category Description Default MCU/RCU
1079 Dynamic
Pr
ovisioning
Dynamic
Tiering
This SOM is set not to run the Proprietary ANCHOR
command during microcode downgrade from a
version that supports the Proprietary ANCHOR
command to a version that does not support the
command.
Mode 1079 = ON: The Proprietary ANCHOR
command is unavailable.
Mode 1079 = OFF (default): The Proprietary
ANCHOR command is available.
Notes:
1. This SOM is applied when downgrading the
microcode from a version that supports the
Proprietary ANCHOR command to a version that
does not support the command.
2. Whether the Proprietary ANCHOR command
can be run or not varies depending on the
setting combination of SOM 1079 and HMO 97
as follows:
a. SOM 1079 setting ON/HMO 97 setting ON
--> Proprietary ANCHOR command
Unavailable
b. SOM 1079 setting ON/HMO 97 setting OFF
--> Proprietary ANCHOR command
Unavailable
c. SOM 1079 setting OFF/HMO 97 setting ON
--> Proprietary ANCHOR command
Available
d. SOM 1079 setting OFF/HMO 97 setting OFF
--> Proprietary ANCHOR command
Unavailable
OFF -
System option modes
Appendix B: System option modes
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 339