Hitachi WJ200 Series

Chapter 10 WJ-PN Specification
62
10.1 WJ-PN Specifications
Item
Specification
Installation
Unit type
WJ200 / WL200 Series Option Board
*1
Model
WJ-PN
Dimensions (W x H x D)
68 x 60 x 45[mm]
Weight
170[g] (typical)
Environment
Ambient operating
temperature
-10 to 50[degree] (no icing or condensation)
Ambient operating humidity
20 to 90[%], RH
Storage temperature
-20 to 65°C (no icing or condensation)
Vibration resistance
5.9[m/s
2
] (0.6[G]) at 10 to 55[Hz]
Dielectric strength
500[V
AC
] (between isolated circuits)
Conformance to EMC and
electrical safety standards
EN61800-3: 2004 / A1:2012 (2014/30/EU) First
environment, Category C1
*2
EN61800-5-1: 2007 (2014/35/EU)
Enclosure rating
IP 20
PROFINET
Interface
Communications protocol
PROFINET IO Ver2.32
Device type
PROFINET IO Device
Conformance class
B
Protocol
DCP, LLDP, SNMP
Netload
I
RT / IRT
only RT
Profile
PROFIdrive
Physical layer
Auto negotiation
(100BASE-TX (IEEE802.3) only)
port
2 ports
Connector
RJ45 (Port1 / 2)
MAC address
3 (Host, Port 1 / 2)
Cable
100BX-TX supported (category 5e or higher)
STP cable (straight or cross allowed)
Communications distance
Distance between nodes: 100[m] max
PROFIdrive
Version
4.2
Application class
AC1 (Standard Drive)
Telegram
Standard telegram 1
WJ-PN telegram 103 (same as PPO3 of PROFIdrive
version 2)
WJ-PN telegram 104 (same as PPO4 of PROFIdrive
version 2)
WJ-PN telegram 105 (like PPO5 of PROFIdrive
version 2)
Configuring of telegram
From P160 to P179 of WJ200 / WL200 parameters
Operating mode
Speed control mode
Jogging
Only jogging 1 is supported.
Note1: When WJ-PN is attached to WJ200 / WL200, functional safety is not supported. Please refer
to “5.3 A system configuration of the PROFINET” for details.
Note2: C1 only when installed in a metal cabinet, otherwise C2.