Hitachi WJ200 - BASIC SPECIFICATIONS

To Set the Run Command
Source
To Set the Frequency or Speed
1
Press ESC to enter programming mode
2
Press ESC until parameter A001 is on the
display of your drive
3
Press the UP key until A002 is reached
4
Then press the SET key to enter the A002
parameter
5
Now you can select the run command source
from the options below
01- To use the digital
input via the
terminals
02- When your
application calls
for using the
Keypad for run
command
03- Use this
option when
commanding
your drive to run
via your Modbus
communication
network
04- Option card used
for run
6
Press the SET key to save the data
1
Press ESC to enter programming mode
2
Press ESC until parameter F001 is on the
display of your drive
3
Then press the SET key to enter the F001
parameter
4
Now you can adjust the speed of your drive
based on your application
5
Press the SET key to save the data
F001 parameter can be adjusted with your drive
stopped or running.