Hitachi WJ200 - POWER CIRCUIT WIRING

To Set the Acceleration Time To Set the Deceleration Time
1
Press ESC to enter programming mode
2
Press ESC until parameter F001 is on the
display of your drive
3
Press the UP key until F002 is reached
4
Then press the SET key to enter the F002
parameter
5
Now you can adjust the acceleration time of
your drive based on your application. The
time is adjusted using the UP and Down keys
6
Finally, press the SET key to save the data
1
Press ESC to enter programming mode
2
Press ESC until parameter F001 is on the
display of your drive
3
Press the Up key until F003 is reached
4
Then press the SET key to enter the F003
parameter
5
Now you can adjust the deceleration time of
your drive based on your application. The
time is adjusted using the UP and Down keys
6
Press the SET key to save the data