To Set the Stop Mode
1
Press ESC to enter programming mode
2
Press ESC until parameter b001 is on the
display of your drive
3
Press and hold the UP key until b091 is
reached
4
Then press the SET key to enter the b091
parameter
5
Now you can select the Stop Mode from the
options below
00- decelerate to stop
(controlled stop)
01- free run stop
(coast)
6
Press the SET key to save the data
TECH SUPPORT
980-500-7141
WEBSITE
www.hitachi-america.us/ice/inverters
EMAIL
inverterinfo@hal.hitachi.com
SCAN THIS QR CODE
to access the manual
or register your
product for warranty
To Previous Page
Loading...
