HITEC Smart Charger H4 User Manual

Instruction Manual

HITEC Smart Charger H4 Specifications

General

Brand	HITEC
Model	Smart Charger H4
Category	Battery Charger
Language	English

Summary

Specifications

Warnings and Safety Information

Warning and Error Messages

System Setup Mode

Set Charge C-Rate

Set Discharge C-Rate

Set Minimum Input Voltage

Set Input Current Limit

Smart Detect at Balancing Charge

Factory Default Reset

Lithium Battery Charging - Quick Start Program

Battery Memory Save/Load

Quick Start Program for Lithium Batteries

Guides through initial setup for charging LiPo, LiFe, and Lilon batteries.

Lithium Battery Charging - Advanced Setup

Set Charge End Voltage

Configure the maximum voltage for safe lithium battery charging.

Set Discharge End Voltage

Set the minimum voltage for safe lithium battery discharging.

Set Charge/Discharge Current

Adjust the current rate for charging and discharging lithium batteries.

Set Cycle Interval Time

Set Safety Temperature

Set a maximum temperature limit for charging/discharging lithium batteries.

Set Safety Timer

Set a maximum time limit for charge/discharge operations to prevent damage.

Set Maximum Battery Capacity

Set Constant Voltage Hold Mode

Battery Storage Mode

Storage Mode Start Operation

Lithium Battery Balance Checker

Cell Balance Check Function

Checks individual cell voltages and capacity status for lithium batteries.

NiCd/NiMH Battery Charging - Quick Start Program

Select Battery Type (NiCd/NiMH)

Choose the correct battery chemistry (NiCd or NiMH) for charging.

Set Battery Capacity

Input the battery's capacity in mAh for accurate charging.

Select Number of Cells

Specify the number of cells in the battery pack.

Charge/Discharge Amperage Setup

Configure the charging and discharging amperage for the battery.

Normal/Linear Charge Mode

NiCd/NiMH Battery Advanced Setup

Delta Peak Detection Settings

Configure delta peak voltage detection for automatic charge termination.

Delta Peak Delay Settings

Trickle Current Settings

Minimum Discharge Voltage

Set the minimum safe voltage for battery discharging.

Charge/Discharge Cycle Delay Time

Safety Temperature Settings

Configure the safety temperature limit for battery operations.

NiMH/NiCd Battery Cycle Mode

Safety Timer Settings

Set a maximum time limit for cycle mode operations.

Maximum Battery Capacity Settings

Battery Cycle Mode Usage

Setting Number of Cycles

Setting Cycle Start Mode

Lead Acid (Pb) Battery Charging Program

Select Pb Battery Type

Choose the Lead Acid battery type for charging.

Select Number of Cells for Pb Battery

Specify the number of cells in the Lead Acid battery pack.

Set Pb Battery Capacity

Input the capacity in Ah for accurate Lead Acid battery charging.

Normal/Pulse Charge Mode for Pb

Lead Acid (Pb) Battery Advanced Setup

Set Minimum Discharge Voltage for Pb

Set the minimum safe discharge voltage for Lead Acid batteries.

Set Charge/Discharge End Current for Pb

Configure the final current at the end of Pb battery charge/discharge.

Set Trickle Current for Pb

Set Safety Temperature for Pb

Set a temperature limit for Pb battery operations.

Set Safety Timer for Pb

Set a maximum time limit for Pb battery charge/discharge.

Set Max Battery Capacity for Pb

Battery Discard Mode

Accessing Battery Discard Mode

Confirming Battery Discard

Hitec Channel Bridge Charging

Channel Bridge Setup

Configure settings for bridging two charger channels for higher output.

Channel Bridge Charging Operation

[A.B.C.D] Type Configuration

[A+B, C+D] Type Configuration

[A, B, C+D] or [A+B, C, D] Type Configuration

Connecting the Bridge Cable

Service and Support

Warranty Information

Repair and Servicing Instructions