HITEC X4 AC Pro - NiMH; NiCd Auto Charge Mode

24
NiMH / NiCd Battery Program (cont.)
............................
BATTERY CHECK
Program Start
Press and hold the START START/ENTER button until
you see “BATTERY CHECK...” the battery should then
begin charging.
Once charging has started the screen will display the
battery type, charge rate, total pack voltage, elapsed
time, and total current fed in mAh.
Once the battery is fully charged, the screen will read “END: FINISHED” and the
charger will emit a chiming sound. You can press the ■ button at any time during the
charging process to stop charging.
NiMH 1.3A 6.00V
CHG 009:11 00411
66
NiMH / NiCd Auto Charge Mode
In this mode, the charger automatically detects the connected NiMH or NiCd
battery and determines the proper full charge and cuto thresholds. Setting the
upper charge current limit for safe levels based on your battery specications
will ensure safe charging of your specic battery. If you are unsure of the
maximum allowable charge rates, set the charger to a maximum of 1C (battery
mAh/1000, i.e., 2500mAh = 2.5A).
After selecting the correct battery type use the INC
and DEC to scroll to Auto CHARGE Mode. Press the
START/ENTER button to conrm.
Setting the Charge Current
Press INC and DEC to increase or decrease the charge
current. Press the START/ENTER button to conrm the
setting. The rate can be adjusted from 0.1 ~ 10A.
Program Start
Press and hold the START START/ENTER button until you see “BATTERY
CHECK...” the battery should then begin charging.
Once the battery is fully charged, the screen will read “END: FINISHED” and the
charger will emit a chiming sound. You can press the ■ button at any time during the
charging process to stop charging.
CURRENT 2.0A
NiMH Auto CHARGE
CURRENT 2.0A
NIMH CHARGE