HITEC X4 AC Pro - NiMH; NiCd Re-Peak & Cycle Modes

25
NiMH / NiCd Battery Program (cont.)
NiMH / NiCd Discharge Mode
After selecting the correct battery type use the INC
and DEC to scroll to DISCHARGE Mode. Press the
START/ENTER button to conrm.
Setting the Discharge Current
Press INC and DEC to increase or decrease the charge
current. Press the START/ENTER button to conrm the
setting. The rate can be adjusted from 0.1 ~ 2.0A.
Setting the Cut-O Voltage
Press INC and DEC to increase or decrease the cut-o
voltage Press the START/ENTER button to conrm the
setting.
Make sure to follow the instructions provided with your battery
when setting the voltage cuto. The X4 AC Pro will stop discharging
when the battery has reached the preset voltage cuto.
Program Start
Press and hold the START START/ENTER button until you see “BATTERY
CHECK...” the battery should then begin discharging.
Once discharging has commenced, the charger will
display the following information: battery type, dis-
charging current, battery voltage, discharging time and
discharged capacity.
When discharging is complete, the screen will read “END:CUTOFF-VOL” and the
charger will emit a ringing sound. The charger will display the elapsed time, end
voltage and the discharged capacity in mAh. You can press the ■ button at any time
during the charging process to stop charging.
NiMH / NiCd Re-Peak Mode
Applicable to NiMH and NiCD batteries only, in re-peak mode the charger can
peak charge the battery once, twice, or three times in a row automatically. This
process is good for conrming the battery is fully charged and for verifying how
well the battery can accept a fast charge. A ve-minute cool-down delay occurs
after each re-peak charge.
CURRENT 2.0A
NiMH DISCHARGE
1.0A CUT: 3.2V
NIMH DISCHARGE
1.0A CUT: 3.2V
NIMH DISCHARGE
Caution
NiMH 1.3A 4.90V
DCH 003:44 00450
66