HITEC X4 AC Pro - Page 26

26
NiMH / NiCd Battery Program (cont.)
IN REPEAK MODE, THE X4 AC PRO USES THE CHARGE AMPERAGE
AND VOLTAGE SETTINGS ENTERED IN CHARGE MODE SEE PAGE 20.
Note
After selecting the correct battery type, use the INC or
DEC buttons to select the “RE-PEAK” mode. Press the
START/ENTER button to conrm.
The number of Re-Peak cycles will begin ashing use
the INC or DEC buttons to select the number of Re-
peak cycles you want to perform up to 3 total cycles.
Program Start
Press and hold the START START/ENTER button until you see “BATTERY
CHECK...” the battery should then begin Re-Peak charging.
Once Re-Peak process has begun, the charger will
display the following real-time information: battery
type, charging current, battery voltage, elapsed time
and charged capacity.
Once the Re-Peak process has completed, the screen will read “END: RE-PEAK”
and the charger will emit a chiming sound. The X4 AC Pro will display the
charge/discharge capacity for each cycle. Using the + and - buttons, you can
scroll through this data for each cycle.
NiCD/NiMH Cycle Mode
The X4 AC Pro makes cycling of NiCD/NiMH batteries easy. The process of
discharging and recharging (cycling) can be achieved automatically with one
simple step and will improve the performance of NiCD/NiMH batteries. We
strongly recommend cycling any battery that has been discharged and stored
for a period of time. This will increase battery life and improve performance.
FOR CYCLING, THE X4 AC PRO USES THE CHARGE/DISCHARGE AMPERAGE
AND VOLTAGE SETTINGS ENTERED IN THE CHARGE AND DISCHARGE
MODES SEE PAGES 20 ~ 22.
After selecting the correct battery type use the INC
and DEC to scroll to CYCLE Mode. Press the START/
ENTER button to conrm.
1
NiMH RE-PEAK
1
NiMH RE-PEAK
NiMH 1.3A 5.90V
RPC 005:33 00581
Note
CHG>DCHG 1
NiMH CYCLE
66